The SANIVITE designed to allow an extra kitchen or utility room to be installed where no drain is present. it has been specially designed for use with hot soapy water such as the kitchen waster.
The Sanivite Pump can also be used to connect a sink, washing machine, glass washer, bath, shower, dishwasher or basin. It uses 32 mm pipework, pumps waste water away with a vertical pumping capacity of 5m, horizontal discharge of 50 m or a lesser combination of both. Its unique design reduces the noise level when in operations.
Sanivite has also recently been remodelled to give greater sound reduction.
· SANIVITE 1004
· Manufactured by Saniflo
· Takes waste from Washbasin, Bath, Shower, Power Shower, Washing Machine, Dishwasher & Sink
· Motor: induction motor (no carbon brushes or gears to wear out). Tested over 30,000 cycles.
· Watts (Consumption): 360w
· Electrical Supply: 220-240V 50Hz
· Flow rate at max head l/min: 50
· Horizontal Discharge: 50 metres
· Vertical Discharge: 5 metres
· Gravity fall on horizontal installations: 1:100
· Discharge Pipe Diameter: 32mm
· Working Temperature: 35oC
· Maximum Temperature: 60oC
· Materials: Polypropylene, C.R.P., stainless steel, Neoprene
· Motor RPM: 2800 RPM
· Dimensions (vertical height is measured from floor level): 373W x 350 O/H x 185D
· 2 year warranty
Technote:
When used with a shower or bath, the shower tray or bath outlet has to be raised 15 cm above the floor. Most of the domestic range units operate at approx 55 decibels and for the flush of a toilet the motor will run for no more than 10 to 20 seconds.
